Considerations regarding Computer Aided Design of a structure to be manufactured in Occam technology, authors: Victoria Soare, Gaudentiu Varzaru, Adrian Zarnescu, Razvan Ungurelu, Ciprian Ionescu.

Occam technology comes with significant changes in the way the electronic modules are made because two processes, the fabrication of the printed circuit board and the

assembly of the electronic module, are replaced by a single one A compact structure containing the components and the interconnection layers are created one by one on a single line production While there are documented several approaches of the domain from the technologist’s point of view, there is not known any document about the

designer’s point of view, except for some hints from the promoter of the new technology This work is focused on the problems that the new approach of realizing the electronic module brings to the designer Since we usually are using Altium Designer as computer aided design software, we investigated what changes occur when designing for Occam technology The primary change is in the PCB Library where all the land patterns should be smaller.

Poster Syswin Solutions SIITME 2018-final corectat2

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this. If you would like to withdraw your consent or learn more about the cookies we're using on this website, please visit our Cookies Policy page.

Close